Each box contains
Main board
LCD Wall Controller
Wireless remote controller
15 ft RJ11 interconnecting wire
Wall Hanger for the wireless remote controller
Transformer
Return air sensor
Evaporator coil sensor
Wiring Diagram and Instructions
Chrome plated Bezel
Jumper wires and spade terminals
Universally fits
Fits to almost any brand in the market and replaces the old control systems.
3 Speed Fan Operation
If you have 2 or 3 speed fan motor, this retrofit kit allows you to operate your fan motor on different speeds at your will.
Auto Diagnostic
Automatically monitors all the components of marine air conditioner and displays alarm if any problem detected. Identifies the nature of the problem. Constantly monitors the status of compressor, coaxial coil temperature, evaporator coil temperature, return air temperature, high pressure switch, low pressure switch
Real Humidity Control with Humidistat
New microprocessor controlled system allows users to set desired humidity level in the cabin. Once dehumidification mode is selected, It’s Hi-tech dual sensor on return air, will sense both the cabin temperature and humidity level. Humidity level can be set to any level by percentage (40%, 50%, 60% etc).
Dual Control
Marine air conditioner Retrofit Kit comes with LCD wall controller and wireless remote controller for convenience.
On/Off Timer
Timer function allows you to start and stop the marine air conditioner automatically.
Centigrade/Fahrenheit Display
You can switch between Fahrenheit and Centigrade with touch of a button. So easy! You don't have to go through formulas or conversion tables to convert from Fahrenheit to Centigrade or vise versa.
* Installation
The retrofit control kit will work with any self contained marine air conditioner. But it is not a plug and play type. It needs a professional Electrician or an HVAC technician to make the installation. All the electrical components of the existing air conditioner ( compressor, fan motor, reversing valve, pressure switches and the pump) must be identified. Their cables must be identified one by one and re-connected to the new control board. In case the existing unit has a separate run and start capacitor for the compressor, it will still work but it is more complicated to do the wiring. Our retrofit control kit is made for 3 speed fan motors ( it gives three different relay outputs for a motor with 3 winding). In case the old unit has a single speed motor, you will not have a speed control function with the new control system. Please download the installation schematics and make sure that you ( or the installer) understands it.
5 
